Swift Electronic Automatic Phase Sequence Corrector
Normally, for any 3 Phase Machines (or) Equipments like AC,UPS,Lifts and Motors, 3 Phase incoming supply has to be given in the right sequence, i.e (R,Y,B).
Swift Electronic Automatic Phase Sequence Corrector
The Phase angle of 120° between the phases R,Y,B is to be maintained to run 3 phase Motors.
If the sequence is changed instead of R,Y,B to R,Y,B the motor tends to rotate in the reverse direction. If the sequence is changed for loads like 3 phase AC,UPS and Lifts, they will stop working due to the inbuilt sequence protection feature. Only when the input sequence is changed manually, they strat functioning.
In the case of 3 phase UPS, due to wrong sequence, the input supply will be cut and it starts working in the battery mode resulting in discharge of battery.
SWIFT – ELECTRONIC AUTOMATIC PHASE SEQUENCE CORRECTOR always gives an output 3 phase supply in the right sequence and maintains 120° between phases, even if the input sequence is interchanged.Thus all the 3 phase equipments continues to run irrespective of the change in input phase sequence.
Unlike other motor loads, a suitable capacity should be chosen for LIFTS which takes almost 5 times starting current and it will be continuous.
SALIENT FEATURES
- FULLY AUTOMATIC/li>
- NO MANUAL INTERVENTION
- SINGLE PHASE PREVENTION
- HIGH/LOW VOLTAGE PROTECTION
- VOLTAGE IMBALANCE PROTECTION BETWEEN PHASES
- OUTPUT IN THE RIGHT SEQUENCE(R,Y,B)
Sutiable Model may be chosen depending on the application and circuit wiring.
Standard models
| SI.NO | MODEL | Capacity (AC3)Amps |
| 1 | PSC-09 | 9 |
| 2 | PSC-16 | 16 |
| 3 | PSC-25 | 25 |
| 4 | PSC-32 | 32 |
| 5 | PSC-40 | 40 |
| 6 | PSC-50 | 50 |
| 7 | PSC-60 | 60 |
*Higher capacities can be supplied against order